Maintenance ONBOARD

Types of Maintenance Procedures

1) Preventive or Scheduled Maintenance System

It is famously known as the PMS or Planned Maintenance System. In this type of system the maintenance is carried out as per the running hours like 4000 hrs, 8000 hrs etc., or by the calendar intervals like 6 monthly, yearly etc. of the machinery. The maintenance is carried out irrespective of the condition of the machinery. The parts have to be replaced if it is written in the schedule, even if they can be still used.

2) Corrective or Breakdown Maintenance

In this system, maintenance is carried out when the machinery breaks down. This is the reason it is known as breakdown maintenance. This is not a suitable and good method as situations may occur wherein the machinery is required in an emergency. The only advantage of this system is that the working of machinery parts is used to its full life or until it breaks. This system might get costly as during breakdown several other parts may also get damaged.

3) Condition Maintenance system

In this system, the machinery parts are checked regularly. With the help of sensors etc. the condition of the machinery is accessed regularly and the maintenance is done accordingly. This system requires experience and knowledge as wrong interpretation may damage the machinery and lead to costly repairs which may not be acceptable by the company.

Comments

Fresh Water Generator

Converting Seawater to Freshwater on a Ship: Fresh Water Generator Explained Fresh water generator , one of the important machinery on board a ship, is something that cannot be done without. Fresh water produced from fresh water generator is used for drinking, cooking, washing and even running other important machinery which use fresh water as a cooling medium. Fresh water is generally produced on board using the evaporation method. There are two things that are available in plenty on ship to produce fresh water –Seawater and heat. Thus fresh water is produced by evaporating sea water using heat from any of the heat source. The evaporated sea water is then again cooled by the sea water and the cycle repeats. Generally the heat source available is taken from the main engine jacket water, which is used for cooling the main engine components such as cylinder head, liner etc. The temperature available from this jacket water is about 70 deg. centigrade. But at this temperature the evaporati...

Shaftline 1.rudder stock, 2.rudder, 3.propeller bonnet, 4.propeller, 5.stern frame, 6.stern tube sealing, 7.stern tube bearings 8.stern tube, 9.propeller shaft, tail shaft, 10.plummer Mock, pillow block, shaft block, 11.intermediate shaft, 12.thrust shafts 13.flywheel, 14.crankshaft, shaft alley, shaft tunnel,

DIESEL ENGINE

The diesel engine source: Helmut Hütten, "Motoren", Motorbuchverlag Stuttgart, Umschlag Already early Rudolf Diesel (1858 - 1913) was interested in engines. In his youth he was fascinated by the engines of Lenoir and the steam engines that were usual at his time. During his study he learned of his teacher, professor Linde, a famous inventor, that the thermal engine could reach by far a better performance. He referred to the young Frenchman Sadi Carnot (1796 - 1832), who discovered the Carnot' cyclic process, a physical principle that describes the ideal process of the burn in an engine (read more about it in the physics section). Diesel was pursued from now on by the thought to build such an engine. 1890, Diesel had the crucial idea, how the cumbustion process could be improved: The engine takes in just air, which is to be compressed now to a pressure of about 200 bar. At this point, heavy fuel (such as crude oil or petroleum) gets injected by an injector in the air that ...

Mariner Mani

Search This Blog